Infocus lp760 Benutzerhandbuch

Follow this procedure if your computer is an HP workstation or X 
terminal, an IBM RS6000/220, a DEC VAXstation or DECstation 3100 
or a Tektronix X terminal.

1. Locate your monitor cable; it connects the monitor to the com-

puter. Unplug it from the computer. Remember where you 
unplugged the cable from the computer, you will plug the 
LitePro cable into this same connector in the next step.

2. Attach one of the BNC adapters to the “Computer” end of the 

LitePro cable. Plug the adapter (with the cable attached) into the 
monitor connector on the computer.

3. Attach the other BNC adapter to the “Monitor” end of the LitePro 

cable. Plug the adapter (with the cable attached) into the com-
puter’s monitor cable.

4. Tighten the thumb screws on all the connectors to ensure proper 

grounding.

5. Turn on the monitor.

6. Turn on the LitePro 760 by pressing the “1” side of the power 

switch. (Refer to “Powering Up the LitePro” on page 15.)

7. Turn on the computer.

Osprey.bk  Page 10  Monday, December 11, 2000  1:38 PM