Infocus sp5000 Verweisanleitung
9
Displaying a video image
Remove the lens cap.
Press the Power button on the top of the projector or the remote.
The fans start to run. When the lamp comes on, the startup screen is dis-
played. It can take a minute for the image to achieve full brightness.
The fans start to run. When the lamp comes on, the startup screen is dis-
played. It can take a minute for the image to achieve full brightness.
? No startup screen?
Get help on page 12.
Plug in and turn on the video device.
The video device’s image should appear on the projection screen. If it
doesn’t, press the Source button on the keypad or remote.
doesn’t, press the Source button on the keypad or remote.
Adjust the height of the projector by pressing the release button to extend
the elevator foot. Rotate the leveling foot, if necessary.
the elevator foot. Rotate the leveling foot, if necessary.
Position the projector the desired distance from the screen at a 90 degree
angle to the screen. See page 36 for a table listing screen sizes and distances
to the screen.
angle to the screen. See page 36 for a table listing screen sizes and distances
to the screen.
remove lens cap
press Power button
turn on video device
vesa 1
L
audio in
compone
nt 3
serial con
trol
dv1 2
video 5
trigger
R
S-video
4
adjust height
rotate
leveling
foot
leveling
foot
elevator
foot
foot
release button
adjust distance
vesa 1
L
audio in
compone
nt 3
serial con
trol
dv1 2
video 5
trigger
R
S-video
4