ICOM ic-f3 Gebrauchsanleitung
D UNPACKING
The transceiver comes supplied with
the following accessories*.
The transceiver comes supplied with
the following accessories*.
q Flexible antenna
w Belt clip
e 1922A REAR-SHEET
w Belt clip
e 1922A REAR-SHEET
*The BP-196
BATTERY PACK
comes at-
tached to the transceiver.
D BELT CLIP
Attach the belt clip to the transceiver as illustrated below.
D ANTENNA
The antenna screws onto the trans-
ceiver as illustrated below.
The antenna screws onto the trans-
ceiver as illustrated below.
Attach the belt-clip
Release the belt-clip
q
w
e
GETTING STARTED
1
1
D TURNING POWER ON
Rotate the volume control to the 12 o’clock
position.
Rotate the volume control to the 12 o’clock
position.
• A power-up alert tone sounds for about
2 sec. and an opening message may
appear.
appear.
(Above functions depend on pre-setting.)
Then a channel number appears on the
display.
display.
Channel number may differ from this.
NOTE: If the power-up alert tone does
not sound or a channel number does
not appear on the display, turn the
transceiver OFF, check the battery,
then turn the transceiver back ON.
If the power-up tone still does not
sound or a channel number does not
appear, charge the battery or replace
it.
not sound or a channel number does
not appear on the display, turn the
transceiver OFF, check the battery,
then turn the transceiver back ON.
If the power-up tone still does not
sound or a channel number does not
appear, charge the battery or replace
it.
NOTE: To increment or decrement the
displayed channel, push [Y] or [Z]
keys.
displayed channel, push [Y] or [Z]
keys.
MR
IC-F3/S,F4/S SMATRA 7/29 01.12.5 6:02 PM ページ1