ENCORE ENHWI-G3 Betriebsanweisung

This Wireless LAN radio device has been evaluated under FCC Bulletin OET 65 and found 
compliant to the requirements as set forth in CFR 47 Sections 2.1091, 2.1093, and 15.247 (b) (4) 
addressing RF Exposure from radio frequency devices. The radiated output power of this 
Wireless LAN device is far below the FCC radio frequency exposure limits. Nevertheless, this 
device shall be used in such a manner that the potential for human contact during normal 
operation is minimized. 

When nearby persons has to be kept to ensure RF exposure compliance, in order to comply with 
RF exposure limits established in the ANSI C95.1 standards, the distance between the antennas 
and the user should not be less than 20 cm. 

This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable 
protection against harmful interference in a residential installation. 

This equipment generates, uses, and can radiate radio frequency energy. If not installed and 
used in accordance with the instructions, it may cause harmful interference to radio 
communications. 

However, there is no guarantee that interference will not occur in a particular installation. If this 
equipment does cause harmful interference to radio or television reception, which can be 
determined by turning the equipment off and on, the user is encouraged to try and correct the 
interference by one or more of the following measures: 

1. Reorient or relocate the receiving antenna. 

2. Increase the distance between the equipment and the receiver. 

3. Connect the equipment to an outlet on a circuit different from that to which the receiver is 
connected. 

4. Consult the dealer or an experienced radio/TV technician for help. 

This product or software contains encryption code that may not be exported or transferred from 
the US of Canada without an approved US Department of Commerce export license. 

ii