Avaya 1603SW Betriebsanweisung

 for details about specific values. You 

need only specify settings that vary from defaults, although specifying defaults is 
harmless.

VLAN separation controls whether or not traffic received on the secondary Ethernet interface is 
forwarded on the voice VLAN and whether network traffic received on the data VLAN is 
forwarded to the telephone. Add commands to the 46xxsettings.txt file to enable VLAN 
separation. The following three lines will enable VLAN separation when the data VLAN ID is 
"yyy" and the data traffic priority is "z":

●

Enable VLAN separation by setting the parameter to 1:

 SET VLANSEP "1"

●

Define the data VLAN ID (for any computer connected to the second ethernet port on the 
phone) to be 'yyy': 

SET PHY2VLAN "yyy"

●

Define the priority of the data traffic to be 'z': 

SET PHY2PRIO "z"

Note:

When the configuration parameter VLANSEP is set to "1" you should configure 
the network switch so that 802.1Q tags are not removed from frames forwarded 
to the telephone. 

You might have different communities of users, all of which have the same telephone model, but 
which require different administered settings. For example, you might want to group users by 
time zones or work activities. 

Use the GROUP system value for this purpose:

1. identify which telephones are associated with which group, and designate a number for 

each group. The number can be any integer from 0 to 999, with 0 as the default, meaning 
your largest group is assigned as Group 0.

2. At each non-default telephone, instruct the installer or user to invoke the GROUP Craft 

Local procedure as specified in the Avaya one-X™ Deskphone Value Edition SIP for 
1603SW-I IP Deskphones Installation and Maintenance Guide and specify which GROUP 
number to use. The GROUP System value can only be set on a phone-by-phone basis.