Magellan 6000t Betriebsanweisung

13

Press the power button for approximately ten seconds (see “Front View” on page 5). If 
power is connected properly or if the battery is charged sufficiently, the Magellan 
screen will appear followed by the Warning screen. To comply with the warnings, press 
OK. Next, the Quick Tips screen will appear. It is recommended to view the Quick Tips 
to better familiarize yourself with the functionality of the Magellan RoadMate 6000T. 
Otherwise, select 

ESC to skip viewing the Quick Tips at this time. By default, the 

navigation application will launch and the Destination screen will appear. 

The Magellan RoadMate 6000T can be put into “sleep” mode. This mode is a limited power mode that saves battery power. 
When “waking up” from sleep mode, the time to acquire a sattelite fix is significantly shorter than when the Magellan 
RoadMate 6000T is powered up after being completely turned off.

To enable sleep mode, press and hold the Power button for 2-3 seconds. The display will shut off and the power indicator 
light will be on dimly.

To power off completely, press and hold the Power button for 10 seconds.  The Magellan RoadMate will be fully shut off.

To power up the Magellan RoadMate 6000T from sleep mode, press and hold the power button for 2-3 seconds. The 
Warning screen will appear. Select 

OK and you will be taken to the last screen you were viewing.

The Magellan RoadMate 6000T can be configured to automatically go into “sleep” mode after 20 minutes of no keys or 
touchscreen being pressed. Press the 

MENU key on the Magellan RoadMate 6000T then, select System Settings and select 

Power Management. Select the Auto Power Off time and then, select OK. For more information on Power Management, see 
“Power Management” on page 85. 

In the event the Magellan RoadMate 6000T should stop responding, press 

RESET button. If a route was active at the time 

the Magellan RoadMate 6000T was reset, powering the Magellan RoadMate 6000T back on will prompt you to resume, or 
cancel the active route.

The 

VOLUME CONTROL lever is located at the top of the Magellan RoadMate 6000T (see “Top View” on page 7). Use the 

lever to set the volume of the speaker to a desired level. The volume level indicator will appear on screen.

While routing to a destination, if you missed the last verbal command, you can repeat it by pressing the 

VOLUME CONTROL 

lever down.