Epson 1100 Anleitung Für Quick Setup
2
Open the output tray and pull out the extensions.
3
Squeeze the edge guide and slide it left.
4
Load paper against the right edge guide and behind the tab, with the
printable side face up.
printable side face up.
Note:
Don’t load the paper sideways; always load it short edge first.
5
Squeeze the edge guide and slide it over.
Install ink cartridges
Note:
Don’t load paper before installing the ink cartridges.
1
Lift up the printer cover.
2
Open the cartridge cover.
3
Shake the ink cartridges gently 4 or 5 times, then unpack them.
4
Remove only the yellow tape from each cartridge.
Caution:
Don’t remove any other seals from the cartridges.
5
Insert the cartridges in the holder for each color.
4
Unpack
If anything is missing, contact Epson
®
as described on the back of this sheet.
Caution:
Do not open ink cartridge packages until you are ready to install the ink.
Cartridges are vacuum packed to maintain reliability.
Remove all protective materials.
1
Start Here
Please read these instructions before using the printer.
6
Press the cartridges down until they click.
7
Close the ink cartridge cover and press it down until it clicks.
8
Close the printer cover.
9
Press the
ink button to charge the ink. Charging takes about
2.5 minutes.
Note:
Your WorkForce 1100 Series ships with full cartridges and part of the ink
from the fi rst cartridges is used for priming the printer.
Caution:
Don’t turn off the printer while the
power light is flashing or you’ll
waste ink.
Turn on the printer
1
Connect the power cable.
Caution:
Do not connect to your computer yet.
2
Press the
power button.
2
3
*411693900*
*411693900*
Load paper
1
Open the paper support and pull up the extensions.
Series
4116939
Rev.0
1-F
C
4116939
Rev.0
1-F
M
41136939
Rev.0
1-F
Y
4116939
Rev.0
1-F
K
CPD27483_Chor_SH_E.indd 1
6/5/09 1:27:29 PM