Epson 4000 Benutzerhandbuch
Paper Handling
The following section guides you through problems in handling
single sheets of paper and continuous paper. If you are having
single sheets of paper and continuous paper. If you are having
problems using the optional cut-sheet feeder or pull tractor, see
Options later in this chapter.
Single sheets do not feed properly.
l
Paper was inserted in the sheet guide, but the platen did not move and
paper was not fed.
The left edge guide may be set too far to the right so that the
paper detector cannot sense it. Move the paper a little to the left.
The
paper detector cannot sense it. Move the paper a little to the left.
The
PAPER OUT light should go off.
l
Paper was inserted in the sheet guide, and the platen rotated, but paper
was not fed.
Check that the paper release lever is pushed back to the single
sheet position.
sheet position.
Check that the paper guide is installed properly.
The left and right edge guides may be too close together,
preventing
the paper from feeding smoothly. Adjust the position
of the edge guides so that the paper can move up and down
freely.
freely.
The paper may
not be firmly inserted. When feeding thicker than
normal paper, press down lightly on the paper.
Troubleshooting 7-7