Epson 4000 Benutzerhandbuch

There are two ways that the printer can be initialized (returned to

the default settings) through the hardware and one way through the

software. These are described in the following table.

l

The power is turned on.

. The printer receives an INIT signal at the parallel

interface (pin 31 goes LOW).

l

The software sends the ESC @ (initialize the
printer) command.

Default Settings

The table below shows the default conditions that become valid

when the printer is initialized.

Top of form position

Current paper position

Left and right margins

Cancelled

Line spacing

 1/6-inch line spacing

Vertical tab position

Horizontal tab positions

Cleared

Every eight characters

VFU channel

 Channel 0

Font selection

Hardware: The current DIP switch setting

Software: The current SelecType setting

I

Condensed mode

Hardware: The current DIP switch setting

Software: The current SelecType setting

Character spacing

Justification

The current DIP switch setting

Left justification

Special printing effects

Cancelled (except condensed printing)

Graphic mode assignment

ESCK=ESC*0,ESCL=ESC*1,
ESCY=ESC*2,ESCZ=ESC*3

8-15