Epson DLQ-3500 Anleitung Für Quick Setup

For single-sheet multipart forms, use only 
the type of forms that are glued at the top.

To avoid paper jams, do not allow too many 
printed sheets to be stacked on the paper 
guide at one time. Remove the stack when it 
is half as thick as the paper loading limit 
marked on the cut-sheet feeder.

Follow these steps to load paper to the 
cut-sheet feeder:

1. Pull the paper set lever forward until the 

paper guides retract to allow paper 
loading.

2. Release the paper guide lock levers by 

pulling them forward.

3. Slide the right paper guide so that its 

edge is even with the guide mark on the 
cut-sheet feeder and push back the lever 
to lock the paper guide in place. Next, 
slide the left paper guide to roughly 
match the width of the paper.

4. Slide the center support midway 

between the paper guides.

5. Fan a stack of paper, and tap the sides 

and bottom of the stack on a flat surface 
to even it up.

 

c