Epson DLQ-3500 Anleitung Für Quick Setup

2. Turn on Overlapping Forms and Skip 

over perforation settings in the 
default-setting mode.

Note:
When Overlapping Forms is turned on in 
the default-setting mode, the printer 
automatically activates the auto paper 
thickness function even though the 
paper-thickness lever may be set to another 
position.

 

c

❏ Printing on the edge of 

❏ Be sure to turn on 

Overlapping Forms and Skip 
over perforation settings in 
the default-setting mode when 
using this type of paper; 
otherwise your printer may be 
damaged.

3. Follow the instructions in “Loading 

Always tear off and eject overlapping 
multipart forms following the instructions 
described below.

Note:
When Overlapping Forms is turned on in the 
default-setting mode, the Tear Off/Special 
Paper button is disabled and the Load/Eject 
button only feeds forms forward.

1. At the back of your printer, tear off the 

last overlapping multipart form that has 
entered the printer.

2. Press the LF/FF button to eject the last 

overlapping multipart forms forward.

When selecting labels for printing, always 
choose labels mounted on continuous 
backing sheets with sprocket holes for use 
with a tractor. Do not use labels on shiny 
single-sheet backing, because the backing 
sheet tends to slip and may not feed 
properly.

Follow these steps to load labels:

 

c

1. Make sure of the following:

❏ Your software settings keep the 

printing entirely within the 
printable area. For information 
about the printable area, see 
“Printable area” in the Reference 
Guide.

 

c

❏ The auto tear-off function is turned 

off in the default-setting mode.

❏ If you use labels whose backing 

sheet is exposed, make sure the 
paper-thickness lever is not set to 
AUTO. Set it to the appropriate 
position. See “Paper-Thickness 
Settings”  for more information.

2. Load labels as described in “Continuous