Epson EPL-6200 Netzwerkanleitungen

Network Guide

If you are using UNIX or OS/2, you need to use the arp and ping command to set the IP 
address of the network interface. You can also use these commands with Windows 
Me/98/XP/2000/NT 4.0, if you have correctly installed TCP/IP networking on these 
systems.

Note:
❏ Make sure that the Set using PING function is enabled on the TCP/IP menu in EpsonNet 

❏ Make sure the network interface and the computer are in the same segment.

Before you start, you need the following information:

❏ A valid IP address for the network interface. Ask your network administrator for an IP 

address which does not cause conflicts with any other device on the network. If you are 
the network administrator, choose an address within your subnet which does not 
conflict with any other device.

❏ The MAC (Ethernet hardware) address of the network interface. You can find out the 

MAC address on a status sheet.

First, you need to check that the computer can reach to other computer in the same 
segment, as follows:

1. Set the default gateway to the host on which you are setting up the network interface.

If there is a server or a router which acts as a gateway, enter the address of the server 
or the router. If there is no gateway, enter the IP address of your computer as a gateway 
address.

2. Assume that you want to reach to the computer having the IP address 

“192.168.100.101”. Check that the computer is reachable by “pinging” it from the 
command line:
ping 192.168.100.101

3. If the computer is reachable, you can see the following result (the exact form of the 

message depends on your operating system, and the time may vary):
64 bytes from 192:168:100:101:icmp_seq=0. Time=34.ms