Epson EPL-6000 Benutzerhandbuch

7.

Press the SET button to activate the option. The function stops
blinking, and the option starts blinking.

8. Use the    or    button to move to the option you want to set.

9.

Press the SET button. An asterisk (*) appears next to the option,

indicating that the new option has been set. The option stops

blinking and the function starts blinking.

10. To exit 

the emulation submenu and return to the main menu,

use the    or    button to take you back to the main menu. The

message I/F = SERIAL* appears in the display.

If you wish to exit SelecType at 

this point, see the section below on

exiting SelecType.

To exit SelecType (from any main menu or submenu function) and

implement your changes, follow 

these steps:

1. When you have set all the options you want, press the 

button. The printer is set off line.

2.

Hold down the RESET/CONTINUE button for three seconds (until

the message RESET appears) to implement your changes. The

options are implemented in the printer’s memory until you

change them or initialize them to the factory settings.

To implement changes 

to the DATA BUFFER,  OVER

LOAD, and interface submenu settings you must also turn the
printer off. Remember to leave the printer off for at least five
seconds before turning it back on.