Epson EPL-N2550 Netzwerkanleitungen
16
Introduction
The orange light indicates whether the network interface is
connected to 10Base-T or 100Base-TX. The light is on when the
connection is 100Base-TX, or off when the connection is 10Base-T.
connected to 10Base-T or 100Base-TX. The light is on when the
connection is 100Base-TX, or off when the connection is 10Base-T.
Network connector
RJ-45 connector: This connector is used to connect an Ethernet
cable to a network. You can use this cable for both 10Base-T and
100Base-TX.
cable to a network. You can use this cable for both 10Base-T and
100Base-TX.
c
Caution:
You must use a Category-5 shielded twisted-pair cable to connect
the network interface to a network to prevent malfunctions.
You must use a Category-5 shielded twisted-pair cable to connect
the network interface to a network to prevent malfunctions.
About the Software
❏ EpsonNet Config for Windows is a Windows-based
configuration utility for administrators that allows you to
configure the network interface for various protocols such as
TCP/IP, NetWare, MS Network, AppleTalk, IPP, and SNMP.
See "EpsonNet Config for Windows" on page 131.
configure the network interface for various protocols such as
TCP/IP, NetWare, MS Network, AppleTalk, IPP, and SNMP.
See "EpsonNet Config for Windows" on page 131.
❏ EpsonNet Config for Macintosh is a Macintosh-based
configuration utility for administrators that allows you to
configure the network interface for TCP/IP, AppleTalk, and
IPP. See "EpsonNet Config for Macintosh" on page 135.
configure the network interface for TCP/IP, AppleTalk, and
IPP. See "EpsonNet Config for Macintosh" on page 135.
❏ EpsonNet Config with Web Browser is a Web-based
configuration utility that allows you to configure the network
interface for TCP/IP, NetWare, MS Network, AppleTalk, IPP,
and SNMP. See "EpsonNet Config with Web Browser" on
page 137.
interface for TCP/IP, NetWare, MS Network, AppleTalk, IPP,
and SNMP. See "EpsonNet Config with Web Browser" on
page 137.