Epson SQ-2550 Benutzerhandbuch

FCC COMPLIANCE STATEMENT FOR AMERICAN USERS

This equipment generates and uses radio frequency energy and if not installed and used

properly, that is, in strict accordance with the manufacturer’s instructions, may cause

interference to radio and television reception. It has been type tested and found to comply
with the limits for a Class B computing device in accordance with the specifications in

Subpart J of Part 15 of FCC rules, which are designed to provide reasonable protection

against such interference in a residential installation. However, there is no guarantee that

interference will not occur in a particular installation. If this equipment does cause

interference to radio and television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more

of the following measures:

•

Reorient the receiving antenna

•

Relocate the printer with respect to the receiver

•

Move the printer away from the receiver

•

Plug the printer into a different outlet so that the printer and receiver are on different
branch circuits.

If necessary, the user should consult the dealer or an experienced radio/television technician

for additional suggestions. The user may find the following booklet prepared by the Federal

Communications Commission helpful:

“Television Interference Handbook”

This booklet is available from the U.S. Government Printing Office, Washington DC 20402.
Stock No. 004-000-00450-7.

WARNING

The connection of a non-shielded equipment interface cable to this equipment will invalidate

the FCC Certification of this device and may cause interference levels that exceed the limits
established by the FCC for this equipment. If this equipment has more than one interface

connector, do not leave cables connected to unused interfaces.