Epson 1810P Benutzerhandbuch
PowerLite 1810p/1815p
3/08
PowerLite 1810p/1815p
-
3
Use the figure below to help you determine placement. Image
size increases with distance, but can vary depending on how you
position the zoom ring and whether you’ve adjusted the image
with other settings.
size increases with distance, but can vary depending on how you
position the zoom ring and whether you’ve adjusted the image
with other settings.
Also keep these considerations in mind:
❏ Place the projector on a sturdy, level surface.
❏ Make sure there is plenty of space for ventilation around and
❏ Place the projector on a sturdy, level surface.
❏ Make sure there is plenty of space for ventilation around and
under the projector. Do not set the projector on top of
anything that could block the vents under the projector.
anything that could block the vents under the projector.
❏ Make sure the projector is within 10 feet of a grounded
electrical outlet or extension cord.
Ideally, you should place the projector directly in front of the
center of the screen, facing it toward the screen squarely. The
base of the lens should be at about the level of the bottom of the
screen.
center of the screen, facing it toward the screen squarely. The
base of the lens should be at about the level of the bottom of the
screen.
If you place the projector below screen level, you’ll have to tilt it
up by extending the front adjustable foot. This causes the image
to become “keystone” shaped, but you can correct the
distortion.
up by extending the front adjustable foot. This causes the image
to become “keystone” shaped, but you can correct the
distortion.
Turning On and Off the Projector
Turning On the Projector
Turn on any connected computer or video equipment before
starting the projector so it can automatically detect and display
the image source. If you turn on the projector first or have
multiple pieces of connected equipment, you may have to select
the image source manually (see page 5).
starting the projector so it can automatically detect and display
the image source. If you turn on the projector first or have
multiple pieces of connected equipment, you may have to select
the image source manually (see page 5).
Follow these steps to turn on the projector:
1. Open the A/V mute slide (lens cover).
2. Plug one end of the power cable into the projector, and the
other end into an electrical outlet.
The
Power
light turns orange.
3. Press the P
Power
button on the remote control or on top
of the projector.
2.7 to 4.6 ft
5.7 to 9.4 ft
29.7 to 48.2 ft
Distance from screen
TBD
Screen
Projector
Power
light
light