Epson 61p Produktdatenblatt

Epson PowerLite 61p/81p Projector

6/04 Epson PowerLite 61p/81p Projector

5. Use the screwdriver to loosen the two screws holding the

lamp in place. (You can’t remove the screws.)

6. Hold the lamp as shown and pull it straight out.

Warning:
This product includes a lamp component that contains mercury
(Hg). Please consult your state and local regulations regarding
disposal or recycling. Do not put it in the trash.

7. Gently insert the new lamp. If it doesn’t fit easily, make sure

it’s facing the correct way.

8. Once the lamp is fully inserted, tighten its screws.

Caution:
Do not touch the glass portion of the lamp assembly. Touching
the glass could result in premature lamp failure.

9. Lower the lamp cover into place. (The opening should be

almost covered, and the top of the lamp cover should be
flush with the surface of the projector.) Then slide the cover
closed and tighten the screw.

10.Reset the lamp timer as described in the next section.

Resetting the Lamp Timer

You must reset the lamp timer after replacing the lamp to clear
the

Replace the Lamp

message.

Note:
Do not reset the lamp timer if you have not replaced the lamp. If
you do, the

Lamp Hours

will not accurately reflect the number of

hours that the lamp has been used.

1. Connect the power cable and turn on the projector.

2. Press the

button on the remote control and select the

Reset

menu. Then press

Enter

. You see the following:

3. Select

Lamp-Hours Reset

and press Enter. You see the

following:

Don’t remove
these screws