Epson 2480 Garantieinformation

■

Unplug the scanner and the AC adapter, and refer servicing to qualified service personnel 
under the following conditions: The power cord or plug is damaged; liquid has entered the 
scanner or the AC adapter; the scanner or the AC adapter has been dropped or the case 
damaged; the scanner or the AC adapter does not operate normally or exhibits a distinct change 
in performance. (Do not adjust controls that are not covered by the operating instructions.)

■

Unplug the scanner and the AC adapter before cleaning. Clean with a damp cloth only. Do not 
use liquid or aerosol cleaners. Do not apply any liquid directly on the scanner glass.

■

If you are not going to use the scanner for a long period, be sure to unplug the AC adapter from 
the electrical outlet.

■

This product includes a lamp component that contains mercury (Hg). Please consult your state 
and local regulations regarding proper disposal or recycling. Do not put in the trash.

This equipment has been tested and found to comply with the limits for a Class B digital device, 
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection 
against harmful interference in a residential installation. This equipment generates, uses, and can 
radiate radio frequency energy and, if not installed and used in accordance with the instructions, 
may cause harmful interference to radio or television reception. However, there is no guarantee that 
interference will not occur in a particular installation. If this equipment does cause interference to 
radio and television reception, which can be determined by turning the equipment off and on, the 
user is encouraged to try to correct the interference by one or more of the following measures:

■

Reorient or relocate the receiving antenna.

■

Increase the separation between the equipment and receiver.

■

Connect the equipment into an outlet on a circuit different from that to which the receiver is 
connected.

■

Consult the dealer or an experienced radio/TV technician for help.

WARNING: The connection of a non-shielded equipment interface cable to this equipment will 
invalidate the FCC Certification of this device and may cause interference levels which exceed the 
limits established by the FCC for this equipment. It is the responsibility of the user to obtain and 
use a shielded equipment interface cable with this device. If this equipment has more than one 
interface connector, do not leave cables connected to unused interfaces. Changes or modifications 
not expressly approved by the manufacturer could void the user’s authority to operate the 
equipment.

This Class B digital apparatus meets all requirements of the Canadian Interference-Causing 
Equipment Regulations.