Gateway fx4710 Verweisanleitung
www.gateway.com
15
Checking the voltage selection
The power supply, a component built into your computer,
provides power to the system board, add-in cards, and
peripheral devices. The power supply’s voltage selection for
your location is typically set correctly for your location at the
factory, but you can change it to match the electrical service
available in your usage area (such as while in another country).
Use the power selection switch on the back of your computer
to set the voltage to 115V or 230V.
provides power to the system board, add-in cards, and
peripheral devices. The power supply’s voltage selection for
your location is typically set correctly for your location at the
factory, but you can change it to match the electrical service
available in your usage area (such as while in another country).
Use the power selection switch on the back of your computer
to set the voltage to 115V or 230V.
To set the voltage selection switch:
1
Disconnect your computer’s power cable.
2
Use a tool such as an opened paper clip to slide the
voltage selection switch to the correct voltage position.
The switch is located on the back of your computer, near
the power cable connector. To see the location, see
voltage selection switch to the correct voltage position.
The switch is located on the back of your computer, near
the power cable connector. To see the location, see
Connecting to a broadband
modem or network
modem or network
You can connect your computer to a cable or DSL modem or
to a wired Ethernet network.
to a wired Ethernet network.
To connect to a broadband modem or to an Ethernet
network:
1
Insert one end of the network cable into the network
jack
jack
on the back of your computer.
2
Insert the other end of the network cable into a cable
modem, DSL modem, or network jack.
modem, DSL modem, or network jack.
Caution
If you set the voltage selection switch incorrectly, your system will be
damaged. Make sure this switch is set correctly for your location before turning
on your computer. In the United States, the utility power is supplied at a nominal
115 volts at 60 Hz. The power supply should always be set to this when your
computer is operating in the United States. In other areas of the world, such as
Europe, the utility power is supplied at 230 volts at 50 Hz. If your computer is
operating in an environment such as this, the voltage switch should be moved
to 230.
on your computer. In the United States, the utility power is supplied at a nominal
115 volts at 60 Hz. The power supply should always be set to this when your
computer is operating in the United States. In other areas of the world, such as
Europe, the utility power is supplied at 230 volts at 50 Hz. If your computer is
operating in an environment such as this, the voltage switch should be moved
to 230.
Important
Your computer may be equipped with a built-in Ethernet (network) jack.
For information about setting up a wired or wireless Ethernet network, see your
online User Guide.
online User Guide.
8513057.book Page 15 Tuesday, May 6, 2008 9:35 AM