Gateway uc78 Verweisanleitung
CHAPTER 8: Troubleshooting
88
Diskette drive (external)
The diskette drive is not recognized
•
Shut down and restart your notebook.
•
Disconnect the USB cable, then reconnect it.
You see an “Access Denied” or “Write protect” error
message
•
Move the write-protection tab in the upper-right
corner of the diskette down (unprotected).
•
The diskette may be full. Delete unnecessary files
on the diskette and try again.
•
Not all diskettes are IBM-compatible. Make sure
that the diskette you are using is
IBM-compatible.
•
Try a different diskette. Occasionally diskettes
are flawed and cannot be read by the diskette
drive.
You see a “Disk is full” error message
•
Delete unnecessary files on the diskette.
•
Try a different diskette. Occasionally diskettes
are flawed and cannot be read by the diskette
drive.
•
Run Error checking on the diskette. If errors are
detected and corrected, try using the diskette
again. For instructions on running Error
checking, see “Checking the hard drive for
errors” in your online
User Guide
.
You see a “Non-system disk,” “NTLDR is missing,” or
“Disk error” error message
•
Eject the diskette from the diskette drive, then
press E
NTER
.
•
Make sure that the diskette you are using is
IBM-compatible.
The diskette drive status indicator is lit continuously
•
Remove the diskette from the drive. If the
indicator stays on, try restarting your notebook.