OWI IC5 Техническое Руководство

 

Page 3 of 4

 
Attach the speaker wires to the speaker terminals. 

Insert your OWI speaker into the opening and tighten the four screws. As you tighten the screws, the tabs will 
automatically flip into an outward position thereby clamping the drywall between the feet and the flange of the 
speaker. BE CAREFUL NOT TO OVER TIGHTEN, OVER TIGHTENING MAY WARP THE BAFFLE, 
CRACK THE WALL, CAUSE THE FLANGE TO DISTORT AND MAKE THE GRILL DIFFICULT TO 
INSTALL. 

 

Push the grille firmly into the slot in the speaker baffle. 

 

 

 
The speakers' other surfaces are primed to accept ordinary latex wall paint or aerosol spray paint. The surface of the 
speaker behind the grille should remain black and must not be painted. It is necessary to mask this area with the 
center of the template that you have cut out. 

 

The grille can be painted as well, but great care must be taken not to clog the holes in the grille as this will 
greatly reduce the sound quality of the speakers. It is recommended that only light spray painting using 5 parts 
thinning agent to 1 part paint be used. Do not paint the grilles while they are attached to the speaker. 
 

 

The gauge of wire required is determined by the distance between your amplifier/receiver and the speakers. Use 
the following chart as a guide: 

 

 
 
 
 

OWI INC. 
17141 KINGSVIEW AVENUE 
CARSON, CA 90746 

TEL: 310-515-1900     FAX: 310-515-1606 

info@owi-inc.com

 

 
 

 
 
 
 
 
 
 
 
 
 

Less than 10 feet 

18 - 20 Gauge 

10 to 100 feet 

16 to 18 Gauge 

Over 100 feet 

14 Gauge