Heartland hcdwis Betriebsanweisung

17

Dishwasher Features

The PROSCRUB® wash area is located at 
the back of the lower level rack.
NOTE:

 You must select the PROSCRUB® 

wash option to use this feature. Make sure 
items do not interfere with the water feed 
tube, spray arms, or PROSCRUB® spray jets.

Load pans, casserole dishes, etc. in the 

•

back of the lower dish rack with the 
soiled surfaces facing the PROSCRUB® spray jets.
Only one row of items may face the PROSCRUB® spray 

•

jets. Stacking, overlapping or nesting items will keep the 
PROSCRUB® spray jets from contacting all of the surfaces.

 This insert must be used when using the 

PROSCRUB® wash option. All insert tines should be in the up 
position, and the dish should be placed in the open, middle section 
facing the PROSCRUB® spray jets.
The double and single removable rack inserts allow you to adjust 
the rack for the type of load you are washing. This is useful when 
washing a variety of dishes, pots and pans, or roasters.

A.Double rack insert
B. Single rack insert

 It will be easier to install the inserts if you remove the 

silverware basket from the rack.
1. Place the double insert end legs under the 3rd wire from the right 
and single insert legs under the 2nd wire from the right.
IMPORTANT:

 Make sure that the curved wires, on the bottom of 

the insert, fit over the wires in the bottom of the rack.
2. Push down on insert until handle fits against outer rack edge.
3. When center tab under handle locks in under the middle side 
rack wire, the insert is in place.

Pull handle out to the right and lift up to release and lift insert out 
of rack.

Use the utensil basket to hold specialty 
cooking utensils (serving spoons, spatulas, 
and similar items), or overflow silverware 
items.
The basket hangs on the bottom rack in 
the right-hand corner. Load the basket 
while it is on the bottom rack or remove 
the basket for loading on a counter or 
table.
NOTE: Spin the spray arms. Be sure items in the basket do not stop 
the rotation of the spray arms.

This pouch hangs on the front of 
the bottom rack. Use it to hold 
small items that could otherwise 
“fly” around inside the dishwasher 
during a cycle.

After removing the culinary tool rack, you can raise or lower the 
mid level rack to fit tall items in either the mid level or bottom 
rack. Adjusters are located on each side of the mid level rack. Each 
adjuster has 2 preset positions. The high and low positions are 
marked on the adjuster.
IMPORTANT:

 If using the culinary tool baskets in the Down 

position, the mid level rack must also be in the lowest position. 
To raise the rack, press both rack adjusters and lift the rack until it is 
in the Up position and level.
To lower the rack, press 
both rack adjusters and 
slide the rack back to 
its lower position.
NOTE:

 The mid level 

rack must be level.