Sony Ericsson m608c Betriebsanweisung

Mobile phones operate using radio signals, which 
cannot guarantee connection under all conditions. 
Therefore you should never rely solely upon any 
mobile phone for essential communications (e.g. 
medical emergencies).
Emergency calls may not be possible in all areas, on 
all cellular networks, or when certain network 
services and/or mobile phone features are in use. 
Check with your local service provider.

This phone contains a built in antenna. Use of 
antenna devices not marketed by Sony Ericsson 
specifically for this model could damage your mobile 
phone, reduce performance, and produce SAR levels 
above the established limits (see below).

Hold your mobile phone as you would any other 
phone. Do not cover the top of the phone when in use, 
as this affects call quality and may cause the phone to 
operate at a higher power level than needed, thus 
shortening talk and standby times.

Your mobile phone is a low-power radio transmitter 
and receiver. When it is turned on, it emits low levels 
of radio frequency energy (also known as radio 
waves or radio frequency fields). 
Governments around the world have adopted 
comprehensive international safety guidelines, 
developed by scientific organizations, e.g. ICNIRP 
(International Commission on Non-Ionizing 
Radiation Protection) and IEEE (The Institute of 

Electrical and Electronics Engineers Inc.), through 
periodic and thorough evaluation of scientific 
studies. These guidelines establish permitted levels 
of radio wave exposure for the general population. 
The levels include a safety margin designed to assure 
the safety of all persons, regardless of age and health, 
and to account for any variations in measurements.
Specific Absorption Rate (SAR) is the unit of 
measurement for the amount of radio frequency 
energy absorbed by the body when using a mobile 
phone. The SAR value is determined at the highest 
certified power level in laboratory conditions, but the 
actual SAR level of the mobile phone while operating 
can be well below this value. This is because the 
mobile phone is designed to use the minimum power 
required to reach the network.
Variations in SAR below the radio frequency 
exposure guidelines do not mean that there are 
variations in safety. While there may be differences 
in SAR levels among mobile phones, all Sony 
Ericsson mobile phone models are designed to meet 
radio frequency exposure guidelines.
For phones sold in the U.S., before a phone model is 
available for sale to the public, it must be tested and 
certified to the FCC that it does not exceed the limit 
established by the government-adopted requirement 
for safe exposure. The tests are performed in 
positions and locations (that is, at the ear and worn on 
the body) as required by the FCC for each model. For 
body worn operation, this phone has been tested and 
meets FCC RF exposure guidelines when the handset 
is positioned a minimum of 15 mm from the body 
without any metal parts in the vicinity of the phone or 
when used with the original Sony Ericsson body 
worn accessory intended for this phone. Use of other 
accessories may not ensure compliance with FCC RF 
exposure guidelines.