Spectralink E340 Broschüre
PN: 72-9954-00-B.doc
Page 5
Configuring the Wireless Switch from the Default Configuration
Radio settings: The NetLink wireless telephones use an 802.11b radio,
therefore VIEW Certification testing was done with the 802.11b mode only
and not the b/g mode.
therefore VIEW Certification testing was done with the 802.11b mode only
and not the b/g mode.
Commands
Default Settings
VIEW Tested Settings
Beacon-interval 100
100
*
DTIM-period 10
3
*
BG mode
B and G
B only *
Power level
20 dBm
20 dBm
Channel 1
1
Rates
1, 2, 5.5, 11
1, 2, 5.5, 11
Short preamble
Disabled
Disabled *
* Denotes settings that are required for operation with NetLink wireless telephones
Configuring radio settings through the CLI
To configure radio settings for the wireless switch, use the following commands.
To configure radio settings for the wireless switch, use the following commands.
admin>
admin>network
admin(network)>ap
admin(network.ap)>
admin(network.ap)>set beacon intvl 1 100
admin(network.ap)>set dtim 1 3
admin(network.ap)>set rate 1 1,2,5.5,11 1,2,5.5,11
admin>network
admin(network)>ap
admin(network.ap)>
admin(network.ap)>set beacon intvl 1 100
admin(network.ap)>set dtim 1 3
admin(network.ap)>set rate 1 1,2,5.5,11 1,2,5.5,11
Setting the channel
Regulatory parameter values depend on country of operation and radio type.
Refer to documentation for regulatory product information.
Refer to documentation for regulatory product information.
User selection
You can specify the desired channel manually by using the following command.
You can specify the desired channel manually by using the following command.
admin(network.ap)>set reg 1 in 11 20
set reg <access port index> <indoor/outdoor> <channel> <power level>