Spectralink 8020 Installationsanweisungen
FIELD VERIFIED
Access Point Configuration
1. Connect to the AP via Netscape or Internet Explorer by navigating to the URL
http://<IP_Addr> (where <IP_Addr> is the IP address of the AP). Note: these
configuration steps can also be accomplished using the SNMP-based
Avaya/Orinoco ScanTool program.
configuration steps can also be accomplished using the SNMP-based
Avaya/Orinoco ScanTool program.
2. From the main page, click the
Configure
link.
3. To configure WEP settings, obtain the key values from the local network
administrator and use the Avaya AP-3, AP-4 User Guide for guidance in
programming the encryption settings. The WEP configuration screen is reached
programming the encryption settings. The WEP configuration screen is reached
from the main menu by clicking
Configure
, followed by
Security
, followed by
Encryption
.
Note that the NetLink Wireless Telephones must each be configured manually with
the identical WEP settings.
the identical WEP settings.
4. Click
Configure
, then click the
Interfaces
tab and choose the appropriate radio (
Slot
A
or
Slot B
) to configure.
5. From the
Interfaces
tab confirm that the
RTS
/
CTS
Medium
Reservation
Threshold
is greater than 600 or disabled.
6. Set the
Multicast
Transmit
Rate
to
11Mb/s.
7. Next go to the
Bridge
tab, select
SpectraLink
VoIP
to ensure that SpectraLink Voice
Priority (SVP) is enabled.
Conditional: If the AP’s software version is 2.5.xx or later, SVP must be activated
using the Avaya command line interface (CLI).
Connect to the access point via serial interface or Telnet.
Conditional: If the AP’s software version is 2.5.xx or later, SVP must be activated
using the Avaya command line interface (CLI).
Connect to the access point via serial interface or Telnet.
8. To check to see if SVP is enabled:
Type
show spectralink
, then press Enter; it will display
enabled
or
disabled
.
To enable SVP:
Type
set speclinkstatus enable
, then press Enter
.
Conditional: If you are not using a NetLink SVP Server and intend to use 802.11b/g
mode, you must also enter the command:
mode, you must also enter the command:
Type
set speclinklegacysupport,
then press Enter.
9. From the
Bridge
tab, select
Advanced
Filtering
. Enable the
Proxy
ARP
function and
disable
IP
/
ARP
Filtering
.
10. From the
Commands
tab, restart the AP.
The AP is now ready for use with NetLink Wireless Telephones.
PN: 72-9977-00-E.doc
Page 3