Spracht cp-2016 Betriebsanweisung
Installing the Digital Module
1. Power OFF the Aura SoHo™ Conference Phone before changing Modules.
2. Unplug the wall adapter AC power cable.
3. On the under side of the Aura SoHo™ Conference Phone, remove the
lock screw from the Analog Module, if your module has one (see Figure 2).
Module location
Figure 2
Figure 3
Figure 4
Figure 5
4. Remove the Analog Module (Figure 3) and install the Digital Adapter
Module (Figure 4).
5. If you removed a lock screw, replace it now to secure the module.
6. Set Selector Switch 1 on the Digital Adapter Module to ON (Up position,
Figure 5).
7. Plug the AC power cable back into the wall outlet. After a couple of
seconds you will hear 3 tones. This indicates the digital interface is installed
and operational. If you don’t hear the tones, unplug the power cable from
the wall and check to make sure that Switch 1 is in the ON position, then
replug again.
Switch 1
ON