Star Micronics sp349 Installationsanweisungen
HOW TO ATTACH THE WALL METAL FITTINGS OF SP349
1. Unpacking
: Confirm that all accessories are
included.
2. Attaching procedure
:
Note1) Unplug the power plug from the outlet.
Note2) Select a position on the wall which is not
Note2) Select a position on the wall which is not
subjected to mechanical shocks or water
drops. Also confirm that the wall is
sufficiently wide for attaching the bracket.
drops. Also confirm that the wall is
sufficiently wide for attaching the bracket.
2-1 How to attach the bracket
1
If attachment of the bracket on the wall is
not possible,first fix a wooden plate whose
size is more than 120mm
not possible,first fix a wooden plate whose
size is more than 120mm
×
170mm
×
5mm.
2
Apply the bracket and mark the positions
of the screw holes.
of the screw holes.
3
Drill screw holes in the marked positions.
4
Firmly tighten and fix the bracket to the
wall with screws.
wall with screws.
Attach and fix the bracket with the four
φ
4mm screws.
Please prepare screws of sufficient length
to sccure the bracket.
to sccure the bracket.
2-2 How to attach the holder plate
1
Remove the rubber foot.
2
Firmly tighten the two accessory screws
M3 in the direction shown in the figure to
attach the two holder plate onto the printer.
Tightening torque : 9kg fcm
M3 in the direction shown in the figure to
attach the two holder plate onto the printer.
Tightening torque : 9kg fcm
±
1kg fcm
2-3 Setting
Slide the printer main unit downward from
the top of the bracket so that the holder
plate guides it to a secure position.
the top of the bracket so that the holder
plate guides it to a secure position.
Bracket(1)
Holder plates(2)
Not supplied
φ
4mm screws(4)
Please prepare these
φ
4mm screws by yourself.
M3 screws(4)
Bracket
Wall material
Rubber foot
Holder plate
80822265