KYOCERA KM-1815 Bedienungsanleitung
Using COMMAND CENTER
6-7
Basic Page
This section includes settings that apply to the machine, such as Device Defaults, Security, and
basic Networking. Pages in this section are available only to the Administrator (if the Admin
password has been set).
basic Networking. Pages in this section are available only to the Administrator (if the Admin
password has been set).
Setting the Administrator password is highly recommended. See the Security section for other
security options. Function specific settings are found under their respective sections. For example,
scan resolution only applies to scanning and is thus found in the Scanner section. Advanced
networking functions, such as e-mail notification, may be found in the advanced section.
security options. Function specific settings are found under their respective sections. For example,
scan resolution only applies to scanning and is thus found in the Scanner section. Advanced
networking functions, such as e-mail notification, may be found in the advanced section.
Basic > Security > Account Setup Page
The Administrator (Admin) account is the master access account. It controls access to the printer
and networking configuration from all setup and management utilities including the HTML web
pages.
and networking configuration from all setup and management utilities including the HTML web
pages.
The factory default for COMMAND CENTER has no password. Setting the Admin password is
highly recommended to prevent unauthorized changes to the machine and networking
configuration.
highly recommended to prevent unauthorized changes to the machine and networking
configuration.
The password can be up to 30 character long.
Note
We recommend that you record your password so that you do not forget it.
To change the password:
1
Enter the Old Password.
2
Enter the password you want to set in New Password.
3
Enter the same password in Confirm New Password.
4
Click the Submit button.
Basic > Security > Device Page
COMMAND CENTER provides the ability to restrict access to the operation panel.
COMMAND CENTER provides the ability to restrict the type of access that can accomplished from
the operation panel. This can be done by selecting one of the available settings: Lock, Partial Lock,
or Unlock.
the operation panel. This can be done by selecting one of the available settings: Lock, Partial Lock,
or Unlock.
Notes
•
Network access to the machine can be restricted using IP address designations and/or SNMP
settings.
settings.
•
Network access to the machine can be restricted to allow only specific network addresses. See
IP Filter settings.
IP Filter settings.
•
The SNMP Read and Write Community settings function as passwords to control read and
write access to the machine via SNMP. See SNMP settings.
write access to the machine via SNMP. See SNMP settings.
Item
Description
Lock
Prohibits use of the operation panel’s System Menu/Counter key and
prohibits canceling of jobs from the Status Menu.
prohibits canceling of jobs from the Status Menu.
Partical Lock
Prohibits use of the operation panel’s System Menu/Counter key.
Unlock
The operation panel is fully operable.