LG BH9520TW Benutzerhandbuch

19

C

onnecting

Be sure to attach the ferrite core to the power cord 
(for connecting to this unit and wireless receiver). 
This ferrite core can reduce noises.

1.   Press the stopper [a] of the ferrite core to open.
2.   Wind the power cord on the wireless receiver 

once on the ferrite core.

3.   Close the ferrite core until it clicks. 

Refer to the fig.3 and comment.

2 Connecting

Be sure to attach the ferrite core to the speaker 
cable. This ferrite core can reduce noises.

1. Press the stopper [a] of the ferrite core to open.
2. Wind the power code of the unit
 

once

 

on

 the ferrite  core.

3. Close the ferrite core until it clicks. 

Refer to the fig.3 and comment.

 

y If there is a strong electromagnetic wave 

product nearby, interference may occur. Put 
the unit (Wireless Receiver and main unit) 
away from there. 

 

y If there is no audio signal for longer than 

10 minutes, the Wireless Receiver will 
automatically switch to standby mode. In 
power saving mode, both LEDs will turn red. 
LEDs will turn blue or yellow when there is 
any audio signal back.

 

y If you operate main unit then wireless 

speakers (rear speakers) sound within a few 
seconds in standby mode.

 

y Set the distance between this unit and 

Wireless Receiver within 10 m (32 ft.).

 

y Optimum performance can be 

implemented only when the Wireless TX 
and the Wireless Receiver within distance 
of 2 m (6 ft.) to  10 m (32 ft.) is used since 
communication failure may occur if longer 
distance is used.

 

y Be sure to match the speaker cable to the 

appropriate terminal on the components: 
+ to + and – to –. If the cables are reversed, 
the sound will be distorted and will lack 
bass.

 

y It takes a few seconds (and may take longer) 

for the Wireless TX and Wireless Receiver to 
communicate with each other.

 

y Use the rear speaker at least 30 cm (11 inch) 

away from either TV screen or PC monitor.

 

,

Note