Juniper 1-Port SFP Mini-PIM SRX-MP-1SFP Benutzerhandbuch
Produktcode
SRX-MP-1SFP
•
PRBS 2^11-1 (as specified in ITU-T O.153)/2047 pattern
•
PRBS 2^15-1 (as specified in ITU-T O.151/O.153)
•
PRBS 2^20-1 (as specified in ITU-T O.153)
•
Programmable word or 32-bit programmable pattern
•
Network (T1) alarms
•
LOS, LOF, AIS, YLW
Related
Documentation
•
•
•
•
•
•
•
1-Port T1/E1 Mini-Physical Interface Module Basic Configuration
To enable the 1-Port T1/E1 Mini-Physical Interface Module (Mini-PIM) installed on the
SRX Series Services Gateway, you must configure its properties. You can perform the
same configuration tasks using either the J-Web interface or the CLI. In addition, you can
configure a wide variety of options that are not encountered frequently.
SRX Series Services Gateway, you must configure its properties. You can perform the
same configuration tasks using either the J-Web interface or the CLI. In addition, you can
configure a wide variety of options that are not encountered frequently.
•
•
Using the J-Web Interface
To perform basic configuration for the 1-Port T1/E1 Mini-Physical Interface Module and
to configure network interfaces for the services gateway using the J-Web interface:
to configure network interfaces for the services gateway using the J-Web interface:
1.
In the J-Web interface, select Configure>Interfaces>Ports.
The Interfaces page displays and lists the network interfaces present on the services
gateway, along with configuration information (if configured).
gateway, along with configuration information (if configured).
2.
To configure properties for a network interface (Mini-PIM), select the interface name
(t1-1/0/0 or e1–1/0/0), and click Edit.
(t1-1/0/0 or e1–1/0/0), and click Edit.
3.
To use the port on the Mini-PIM, you must assign it to a security zone other than the
Null zone. Optionally, you can also assign the port an IP address (for example,
192.168.3.1/24). Enter or select the following settings:
Null zone. Optionally, you can also assign the port an IP address (for example,
192.168.3.1/24). Enter or select the following settings:
a.
Select Configure>Security>Zones.
b.
Add or select a security zone other than Null; for example, Trust.
Copyright © 2012, Juniper Networks, Inc.
86
SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide