Juniper 1-Port SFP Mini-PIM SRX-MP-1SFP Benutzerhandbuch

Produktcode

SRX-MP-1SFP

NOTE:

The configuration settings given in the following steps are an example.

The actual configuration settings might vary depending on your requirements.

•

Verify that the 1-Port Gigabit Ethernet SFP Mini-PIM is installed on the device:

show chassis hardware

user@host > show chassis hardware

The following is a sample output of the command (SRX240 output shown, other
devices similar):

Hardware inventory:
Item Version Part number Serial number Description
Chassis AG1111AA7925 SRX240h
Routing Engine REV 01 750-021793 PW7925 RE-SRX240H
da0 999 MB ST72682 Nand Flash
usb0 (addr 1) DWC OTG root hub 0 vendor 0x0000 uhub0
usb0 (addr 2) product 0x6254 25172 vendor 0x058f uhub1
usb0 (addr 3) ST72682 High Speed Mode 64218 STMicroelectronics umass0
FPC 0 FPC
PIC 0 16x GE Base PIC
FPC 1 750-029145 112009000278 FPC
PIC 0 1x GE SFP mPIM
FPC 2 REV 00 750-032730 AABC5081 FPC
PIC 0 1x GE High-Perf SFP
mPIM
Xcvr 0 REV 02 740-013111 9101465 SFP-T
FPC 3 750-029145 062009000057 FPC
PIC 0 1x GE SFP mPIM
FPC 4 750-029145 122009000061 FPC
PIC 0 1x GE SFP mPIM
Xcvr 0 REV 01 740-011782 PBL0C3T SFP-SX
Power Supply 0

NOTE:

In the example shown above, the output for the 1-Port SFP Mini-PIM

appears as 1X GE SFP mPIM, and the output for the 1-Port Gigabit Ethernet
SFP Mini-PIM appears as 1X GE High-Perf SFP mPIM.

•

Verify the status of the interface:

show interfaces terse

•

Assign the port an IP address, for example:

set interfaces ge-1/0/0 unit 0 family inet address interface address/destination prefix

•

Add or select a security zone; for example, Trust:

set security zones security-zone trust interfaces ge-1/0/0.0 host-inbound-traffic

system-services telnet

•

Add or select security zones for host inbound traffic protocol options, for example :

SRX Series Services Gateways for the Branch Physical Interface Modules Hardware Guide