LG HB6422BRU Betriebsanweisung

Make sure that the voltage and capacity of the power line conform 

to the data shown on the plate located under the casing. 

remove this plate for any reason.
The plug on the end of the supply cable and the wall socket must 

be the same type and conform to the current electrical system 

regulations. Check that the power line is adequately grounded.
On the power line, install an omnipolar cut-off device with contact 

cut-off distance greater than or equal to 

3 mm, located in an easily 

accessible position near the unit.
Do not use reducers, adapters or shunts.

If the power cable is replaced, the wire section on the new cable 

must not be less than 1.5 mm

2 

(3 x 1.5 cable), keeping in mind 

that the end to be connected to the hob must have the ground 

wire (yellow-green) longer by at least 20 mm. Use only 

H05V2V2-F cable or similar which has a maximum temperature 

of 90°C. Any replacement needed should be carried out by a 

specialised technician who should make the mains connections 

according to the following diagram.
L = brown

N = blue

    = yellow-green

The manufacturer will not be liable for any damage to persons or 

property caused by non-observance of the above instructions or 

deriving from the tampering of even a single part of the hob.