LG 42LS75A-5B Benutzerhandbuch

32

2

  Press the red 

ON button on the remote 

control to assign the 

PICTURE ID.

1 

Assign the 

 

to the installed monitors 

as shown below

.

3 

Assign the 

Set ID to the selection of your 

choice. 

 

•

A set with a different 

Set ID from the 

PICTURE ID cannot be controlled by IR 

signals.

PICTURE ID is used to change the settings of a 

specific set (display) using a single IR receiver 

for multi-vision. Communication is possible 

between a monitor with an IR receiver and 

other monitors using RS-232C cables. Each 

monitor is identified by a 

Set ID. If you assign 

the 

PICTURE ID using the remote control, only 

displays with matching 

PICTURE ID and Set ID 

can be controlled remotely. 

 

•

If 

PICTURE ID is set to 2, only the upper 

right monitor, which has a 

Set ID of 2, can 

be controlled by IR signals. 

 

•

If you press the green 

OFF button for 

PICTURE ID, the PICTURE IDs for all 

monitors are turned off. If you then press 

any button on the remote control, all 

monitors can be controlled by IR signals 

regardless of 

Set ID.

 

•

With 

PICTURE ID ON, you can only 

increase the 

PICTURE ID by 1. You cannot 

decrease it.

NOTE

IR & Light Sensor

RS-232C cables

PICTURE ID ON [2]