Sony PCGA-DVD51 Handbuch

23

Notes
• The following notebook

computers do not
support digital audio
CD playback.

PCG-505GX, 505G

To playback audio CDs
use the audio cable RK-
G136, sold separately,
to connect the DVD-
ROM drive’s LINE
OUT connector and
your notebook
computer’s LINE IN
connector.

• Depending on the

notebook computer
operating mode (while
accessing the hard disk,
etc.) noise may occur
during digital audio
CD playback.

• To adjust the volume,

click the “volume” icon
in the taskbar, or use
the Fn + F4 key.

If you are using a digital audio CD playback-
compatible notebook computer, connecting the DVD-
ROM drive to the notebook computer allows you to
enjoy audio sound via the built-in notebook computer
speaker or headphones. In this case, the audio signal is
not output from the LINE OUT connector on the
DVD-ROM drive.

R

Connect the DVD-ROM drive to the notebook
computer and click the [Start] button, point to
[Settings], and then click [Control Panel].

The “Control Panel” appears.

Double-click [Multimedia].

The “Multimedia Properties” appears.

Click the [CD Music] tab.

Confirm that the “Enable digital CD audio for this
CD-ROM device” checkbox is checked and click
[OK].

If not, check the “Enable digital CD audio for this
CD-ROM device” checkbox and click [OK].

R

Connect the DVD-ROM drive to the notebook
computer and click the [Start] button, point to
[Settings], and then click [Control Panel].

The “Control Panel” appears.

Double-click [Sounds and Multimedia].

The “Sound and Multimedia Properties” appears.

Click the [Hardware] tab.

Select “TOSHIBA DVD-ROM SD-C2402...“ from
the list and click [Properties].

Confirm that the “Enable digital CD audio for this
CD-ROM device” checkbox in the [Properties] tab
is checked and click [OK].

If not, check the “Enable digital CD audio for this
CD-ROM device” checkbox and click [OK].