Sony VRD-P1 Handbuch

Seite von 16
12
VDR-P1 4-134-523-11(1)
If you experience any of the following 
difficulties while using the unit, use this 
troubleshooting guide to help remedy the 
problem before requesting repairs. Refer 
also to the operating instructions of your 
Handycam
. If the problem persists, 
contact your Sony dealer.
The Handycam
 is connected, but the 
unit does not work.
Make sure that your Handycam
 is supported 
by this unit (page 7).
Make sure that the Handycam
 is connected 
to a power outlet by its AC adapter.
Make sure that the Handycam
 is configured 
correctly and the USB cable is connected 
properly to the Handycam
.
Disconnect the USB cable from the 
Handycam
. Turn off the Handycam
, and 
then turn it on again. Then connect the USB 
cable to the Handycam
 again.
Video cannot be recorded to the disc.
Make sure that the disc is compatible with this 
unit (page 7).
Make sure that the disc is new or unused. 
A disc that has already been recorded on or 
formatted by another device cannot be used.
Make sure that the disc has no dust, dirt or 
fingerprints on the recording side. 
Make sure that the disc is placed on the disc 
tray with its recording side down. 
Vibration of the unit may cause a malfunction 
of the Handycam
. Do not place the 
Handycam
 on the unit.
A disc cannot be played.
You can play back only discs created by this 
unit. You cannot play back discs recorded on 
other video devices, or commercially pre-
recorded discs.
Make sure that the disc has no dust, dirt or 
fingerprints on the playback side. 
Make sure that the disc is placed on the disc 
tray with its playback side down.
The disc cannot be ejected.
The 
 (eject) button does not work.
Disconnect the USB cable from the 
Handycam
, turn off the power of the 
Handycam
, then turn it on again, reconnect 
the USB cable to the Handycam
, and then 
press the 
 (eject) button. If this does not 
work, open the disc tray using the emergency 
eject hole (page 9).
The unit can open its disc tray only when it 
is connected to the Handycam
. Make sure 
that the unit is connected to the Handycam
 
properly.
Make sure that the Handycam
 is connected 
to a power outlet using an AC adapter.
The disc cannot be ejected while recording or 
playing a disc.
 Troubleshooting
On use a
Do not use
following l
Anywhe
Never le
60 ºC, su
heaters o
malfunc
Near str
vibration
The unit
Near str
The unit
On a san
If sand o
irreparab
On hand
If the ca
lightly m
casing w
Avoid th
finish:
Chem
chemi
sunscr
Handl
on you
Leavin
vinyl o
Transpo
Please rep
shipping. 
If the unit 
beforehan
Preca