Sony SPOM1 Handbuch

SPOM1

Installation Instructions

The only assembly required on the SPOM1 is attaching a
cable management clip to each side of the mount face
plate.

To attach the cable management clip:

1.

Pull mount face plate outward until access to rear of
face plate can be achieved.

2.

Install two cable management clips (140) into each
side of mount faceplate. (See Figure 2)

The installer is responsible for verifying that

the structure to which the mount is anchored will safely
support five times the combined load of the mount and all
attached components.

To install mount:

1.

Identify appropriate mounting location.

2.

Locate studs.

NOTE: The SPOM1 is designed to be mounted on 16" on

center wood studs.

3.

Place mount assembly against wall, level mount, and
mark pilot hole locations (See Figure 3).

Keep hands and fingers away from pinch

points as mount may move from retracted to extended
position when being positioned on wall.

4.

Drill four .200" pilot holes, at marked locations
(See Figure 3).

5.

Place mount assembly against wall and align
mounting holes in mount assembly with pilot holes
(See Figure 4).

6.

Secure mount to wall studs using four wood screws
(20), and four FW (30).

Face Plate

Cable Management Clip

.200" Pilot Hole
(Mark and Drill)

Mount Assembly

Wall Studs

(20)

(30)