Sony SU-XTQ005 Handbuch
6
(US)
2
Secure the Display Unit to the
Table-Top Stand with the four
display securing screws.
Table-Top Stand with the four
display securing screws.
Note
When using an electric screwdriver, set the torque
setting to about 1.5 N·m.
setting to about 1.5 N·m.
3
Connect the AC power cord and
the display interface cable to the
Display Unit.
the display interface cable to the
Display Unit.
Do not forcefully pull on the cables. Leave some
slack at the connected end as you thread the
cables through the cable holder.
slack at the connected end as you thread the
cables through the cable holder.
z
Hint
See the Operating Instructions supplied with the
Display Unit for details on connecting the AC power
cord and the display interface cable.
Display Unit for details on connecting the AC power
cord and the display interface cable.
Display
securing screw
M5
securing screw
M5
×L16
Display
interface cable
interface cable
AC power cord
Slacken
the cables.
the cables.
Cable holder
4
Attach the cable cover.
1
Push any excess of cable inside the cable
compartment, and slide the cable cover down
until the four tabs of the cable cover snap into
place.
compartment, and slide the cable cover down
until the four tabs of the cable cover snap into
place.
2
Affix the cable cover with the two screws for
the cable cover.
the cable cover.
Adjusting the viewing
angle (swivel)
angle (swivel)
Adjust for the most comfortable viewing angle.
The TV swivels 18 degrees to the left and right.
The TV swivels 18 degrees to the left and right.
Cable cover
Cable cover
securing screw
M4
securing screw
M4
×L12
18°
18°