Nikon SB-26 Benutzerhandbuch
23
22
7
Tighten the locking wheel, taking
care not to over-tighten.
care not to over-tighten.
Checking Battery Power
8
Set power switch to STBY (stand-
by position) or ON to turn on the
by position) or ON to turn on the
speedlight.
If batteries are properly installed/
power is sufficient, ready-light will
come on, and LCD indications will
appear.
If batteries are properly installed/
power is sufficient, ready-light will
come on, and LCD indications will
appear.
LCD figures and symbols for meters
(m) and feet (ft) do not appear simulta-
neously, as shown above. They are
shown together throughout this manu-
al for ease of explanation.
(m) and feet (ft) do not appear simulta-
neously, as shown above. They are
shown together throughout this manu-
al for ease of explanation.
Replace batteries with a fresh set:
With alkaline-manganese batteries — replace if ready-
light takes more than 30 sec. to light up.
With NiCd batteries — remove if ready-light takes
more than 10 sec. to light up.
With alkaline-manganese batteries — replace if ready-
light takes more than 30 sec. to light up.
With NiCd batteries — remove if ready-light takes
more than 10 sec. to light up.
Precaution for Nikon F5, F90X/N90s, F90-
Series/N90 and F70-Series/N70 users
As the locking wheel is tightened, the SB-26 is firmly
attached to the accessory shoe with the mount pin. Be
extra careful that the locking wheel is completely loos-
ened before removing the flash unit from the camera or
it may cause damage to both units.
Series/N90 and F70-Series/N70 users
As the locking wheel is tightened, the SB-26 is firmly
attached to the accessory shoe with the mount pin. Be
extra careful that the locking wheel is completely loos-
ened before removing the flash unit from the camera or
it may cause damage to both units.
Chapter
2
4
Close the battery chamber lid,
then slide cover to close.
then slide cover to close.
Attaching Flash Unit to Camera Accessory Shoe
5
Turn the SB-26’s mounting foot
locking wheel to the loosened
locking wheel to the loosened
position as far as it goes, without forc-
ing.
ing.
6
Slide the mounting foot forward
onto the camera’s accessory
onto the camera’s accessory
shoe as far as it goes.
For Nikon F3 Series users
The SB-26 can only be mounted on an F3 Series cam-
era that uses a DE-2 or DE-3 finder. Be sure to attach
Flash Unit Coupler AS-4 or AS-7 to the camera’s
accessory shoe before mounting the SB-26 on the
camera.
The SB-26 can only be mounted on an F3 Series cam-
era that uses a DE-2 or DE-3 finder. Be sure to attach
Flash Unit Coupler AS-4 or AS-7 to the camera’s
accessory shoe before mounting the SB-26 on the
camera.
Getting Started
SB-26 (E) 03.1.14 7:16 PM Page 22