Nikon SU-800 Benutzerhandbuch

112

Turn on the camera and SU-800.
After turning on the camera, press the [ON/OFF] 
button on the SU-800 to turn on the SU-800 and 
SB-R200.

• The red ready-lights on the SU-800 and SB-R200 

come on when fully recycled.

• Make sure that Close-up mode and Using cords 

indicators appear on the LCD panel.

Setting the flash mode on the SU-800
Press the [MODE] button on the SU-800 to set the 
flash mode to TTL BL, TTL or M.

Activating or canceling the SB-R200’s flash firing
Press the [A

B] select button to set the remote 

flash units in Group A or B to fire or to cancel.

• A remote flash unit on the left as viewed from the 

SU-800’s LCD panel is assigned to Group A, and a 
flash unit on the right is assigned to Group B.

• A flash canceled group indicator disappears.
• You cannot cancel flash firing for both Groups A and B.

Setting the flash output level compensation (in TTL 
BL or TTL mode)
Press the [SEL](FUNC.), or [

W] or [X] button to 

display the flash output level compensation value 
(blinking). Press the [

W] or [X] button to increase 

or decrease the compensation value. Press the 
[SEL](FUNC.) button once again and the value will 
stop blinking. The last value to blink is the one that 
has been set automatically.

• The same value is set for both groups A and B.
• Flash output level compensation values can be set in 

1/3 step increments or decrements from +3.0 to -3.0 EV.

• The values are displayed in decimal format, like 0.3 for 

1/3, and 0.7 for 2/3.

• Pressing the [

W] or [X] button continuously increases 

or decreases the value quickly.

• The compensation value blinks during adjustment and 

stops after blinking six times unless an adjustment is 
made. The last value to blink is the one that has been 
set automatically.

• If the flash output level compensation value is set 0.0, 

the display goes off.

• Being able to set flash output level compensation is 

dependant on camera in use.