Olympus PT-043 Gebrauchsanleitung
EN 18
En
Make sure the camera is loaded properly.
Check the following points before sealing the Case.
• Is the digital camera loaded properly?
• Is silica gel inserted all the way at the specified location?
• Is the O-ring attached properly to the opening on the Case?
• Is there any dirt or foreign matter on the O-ring or the O-ring contact
• Is the digital camera loaded properly?
• Is silica gel inserted all the way at the specified location?
• Is the O-ring attached properly to the opening on the Case?
• Is there any dirt or foreign matter on the O-ring or the O-ring contact
surface on the front lid?
• Is the waterproof function maintenance performed?
Insertion of silica gel
Before sealing the Case, insert the
silica gel bag provided for
prevention of fogging between the
bottom of the camera and the Case.
silica gel bag provided for
prevention of fogging between the
bottom of the camera and the Case.
CAUTION:
• Insert the silica gel all the way at the specified location and with the
specified orientation. When the orientation is not correct, the silica gel bag
will be caught when the Case is sealed and water leakage will occur.
will be caught when the Case is sealed and water leakage will occur.
• If the Case is sealed without inserting the silica gel fully, the silica gel bag
will be caught by the O-ring and water leakage will occur.
• Once silica gel has been used, the moisture absorption performance will
be impaired. Always replace the silica gel when the Case is opened and
closed.
closed.
Pay attention to the orientation
PT-043_EN.book Page 18 Friday, December 7, 2007 5:30 PM