Olympus μ TOUGH-8000 Gebrauchsanleitung

Seite von 82
EN
Before Use:
Check the camera for foreign material
including dirt, dust or sand.
Be sure to close the battery/card compartment
cover and connector cover firmly so that each
lock makes clicking sound.
Do not open the battery/card compartment
cover and connector cover with wet hands,
while under water, or in a damp or dusty
environment (e.g. beach).
After Use:
Be sure to wipe off any excess water or debris
after using the camera under water.
After the camera is used under seawater, 
immerse the camera in a bucket containing 
fresh water for about 10 minutes (with 
the battery/card compartment cover and 
connector cover firmly closed). After 
that, dry the camera in a shade with good 
ventilation.
Water drops may be observed on the inner 
surface of the battery/card compartment 
cover or connector cover after you open 
each cover. If any water drops are found, 
be sure to wipe them off before using the 
camera.
Notes after use
Foreign materials may be attached to the
periphery of the lens cover from using the
camera in conditions with foreign materials
such as dirt, dust or sand, or when the lens
cover is not moving smoothly. If you continue
to use the camera in such conditions, the lens
could become damaged or the lens cover
could stick causing additional damage to the
camera. To avoid such damage, wash the
camera using the following method.
1
Insert the battery and close the battery/
card compartment cover and connector
cover firmly so that each lock makes the
clicking sound.
2
Fill a bucket with fresh water, immerse
the camera in the bucket with the lens
surface downward and shake the camera
thoroughly.
3
Press the n button several times in
the water and close/open the lens cover
repeatedly.
4
Furthermore, shake the camera further
with the cover opened.
Follow the Steps 1 to 4, then check if the
lens cover moves smoothly.
If the lens cover does not move smoothly,
rinse the lens face by placing it directly under
a strong stream of tap water and pressing the
n
button repeatedly.
Storage and Maintenance
Do not leave the camera in an environment at
high temperature (40°C (104°F) or more) or at
low temperature (-10°C (14°F) or less). Failure
to do so may break down water resistance.
Do not use chemicals for cleaning, rust
prevention, anti-fogging, repairing, etc. Failure
to do so may break down water resistance.
Do not leave the camera in water for a long 
time. Failure to do so will cause damage to 
the camera’s appearance and/or deteriorate 
water resistance. 
In order to preserve the water resistant 
feature, as with any underwater housing, 
it is recommended that the waterproof 
packing (and seals) are replaced annually. 
For the Olympus distributors or service 
stations where the waterproof packing can 
be replaced, visit Olympus website for your 
local area.