Olympus PT-042 Gebrauchsanleitung
EN 5
En
Setting the underwater shooting scene mode
z
The µ 1020/Stylus 1020/µ 1010/Stylus 1010 cameras incorporate
several shooting scene modes for underwater shooting, including wide-
angle and macro modes. Simply select the mode that’s most appropriate
for the scene you are shooting.
For details, see “5. Underwater Shooting According to the Scene
Type” (P.24) of this manual.
several shooting scene modes for underwater shooting, including wide-
angle and macro modes. Simply select the mode that’s most appropriate
for the scene you are shooting.
For details, see “5. Underwater Shooting According to the Scene
Type” (P.24) of this manual.
z
For details on mode setting, refer to the digital camera’s operation
manual.
manual.
For Prevention of Water Leakage Accidents
When water leakage occurs while this product is being used, repair of the
camera housed in this product may become impossible. Please observe
the following cautions for use.
1
camera housed in this product may become impossible. Please observe
the following cautions for use.
1
When sealing this product, make sure that no hairs, fibers, sand
particles or other foreign matter stick not only to the O-ring, but also to
the contact surface (front cover). Even a single hair or a single grain of
sand may cause water leakage. Please check with special care.
particles or other foreign matter stick not only to the O-ring, but also to
the contact surface (front cover). Even a single hair or a single grain of
sand may cause water leakage. Please check with special care.
2
The O-ring is a consumable part. Please replace it at least once a year
with a new one. Before each use, perform the proper maintenance.
with a new one. Before each use, perform the proper maintenance.
3
Deterioration of the O-ring will acelerate according to the use
conditions and the storage conditions. Immediately replace the O-ring
with a new one if it is damaged, cracked, or has lost its elasticity.
conditions and the storage conditions. Immediately replace the O-ring
with a new one if it is damaged, cracked, or has lost its elasticity.
4
During O-ring maintenance, clean the inside of the O-ring groove and
confirm the absence of dirt, dust, sand, and other foreign matter.
confirm the absence of dirt, dust, sand, and other foreign matter.
5
Apply the specified silicone grease to the O-ring.
Examples of foreign matter sticking to the O-ring
Hair Fibers
Grains
of
sand
PT-042_EN.book Page 5 Tuesday, December 11, 2007 1:09 PM