Netgear GSM7224v2 - 24-Port Layer 2 Managed Gigabit Switch Benutzerhandbuch
Chapter 4. Routing
|
297
ProSafe® Gigabit L3 Managed Stackable Switches Software Administration Manual
OSPFv3 Configuration
Use the OSPFv3 Configuration page to activate and configure OSPFv3 for a switch.
To display the OSPFv3 Configuration page, click Routing
OSPFv3
Basic
OSPFv3
Configuration.
1.
Use Admin Mode* to select enable or disable. If you select enable, OSPFv3 will be
activated for the switch. The default value is disable. You must configure a Router ID
before OSPFv3 can become operational. This can also be done by issuing the CLI
command router-id, in the IPv6 router OSPF mode.
activated for the switch. The default value is disable. You must configure a Router ID
before OSPFv3 can become operational. This can also be done by issuing the CLI
command router-id, in the IPv6 router OSPF mode.
2.
Use Router ID to specify the 32-bit integer in dotted decimal format that uniquely identifies
the router within the autonomous system (AS). If you want to change the Router ID you
must first disable OSPFv3. After you set the new Router ID, you must re-enable OSPFv3 to
have the change take effect. The default value is 0.0.0.0, although this is not a valid Router
ID.
the router within the autonomous system (AS). If you want to change the Router ID you
must first disable OSPFv3. After you set the new Router ID, you must re-enable OSPFv3 to
have the change take effect. The default value is 0.0.0.0, although this is not a valid Router
ID.
Note:
*Once OSPFv3 is initialized on the router, it will remain initialized
until the router is reset.