Netgear AirCard Hub Betriebsanweisung

2400164

AirCard Hub User Guide

NAT

The NAT page is used to configure the Network Address Translation rules currently in

use on the AirCard Hub. The AirCard Hub is in NAT mode by default.

Figure 27: NAT Settings

This is only needed if you need to map inbound requests to a specific port on the

WAN IP address to a device connected on the Ethernet interface, for example, a web

camera.

Option

Definition

Mapping no

For each mapping you’re defining, enter a unique
number, and then enter the details in the following
fields.

Protocol

Specify the protocol to use for the port mapping (TCP,
UDP, All protocols).

Source IP Address

Specifies either a “Friendly” IP address that is allowed
to access the AirCard Hub, or a wildcard IP address of
0.0.0.0 that allows all IP addresses to access the
AirCard Hub.

Incoming Port Range

Specify the external port(s) to listen to.

Destination IP Address

Local Area Network address of the device to forward
inbound requests to.

Destination Port Range

Local Area Network port(s) to forward connections to.

To configure Port Forwarding:

1. Enter the IP Mapping configuration information as appropriate.
2. Click Save NAT.

Note: If the “Incoming Port Range” specifies a single port, then the destination port can be

set to any port. If the “Incoming Port Range” specifies a range of port numbers then the

“Destination Port Range” MUST be the same as the “Incoming Port Range”.

To delete a port forwarding rule, click the corresponding “Delete Entry” link from the

list of IP Mappings.