Netgear AirCard 803S (Sprint) – 4G LTE Tri-Fi Hotspot Betriebsanweisung
Device Settings
95
From this window, you can view or adjust these settings, or perform the following actions:
● Router IP Address — This is the routing hardware’s IP address on the LAN.
● Subnet Mask — This is the routing hardware’s internal LAN subnet mask.
.)
● Link SSID and Hostname — With this feature you only need to remember one name
when selecting the Wi-Fi network, accessing the browser interface, or accessing the
microSD card. (See
microSD card. (See
.)
.)
● MTU — This specifies whether optimization is used.
Auto — Optimization is not used.
Optimized (recommended setting) — Optimization is used; this may improve data
transmission.
Manual — Optimization is used; this may improve data transmission. After selecting
the radio button, enter the value to use (1200–1500).
● DHCP Server — This field enables DHCP.
Note: The following settings are displayed only when DHCP is enabled.
● DHCP IP Address Range — This specifies the starting and ending address of the range
of IP addresses available for the device to dynamically (that is, not permanently) assign
to computers connected to it.
to computers connected to it.
● DHCP Lease Time — This is the amount of time, in minutes, a computer can use its
assigned IP address before it is required to renew the lease. After this time is up, the
computer is automatically assigned a new dynamic IP address.
Enter a number between 2 and 10080.
computer is automatically assigned a new dynamic IP address.
Enter a number between 2 and 10080.
● Max DHCP Clients — This is the number of DHCP addresses that can be assigned and
active at one time. It’s recommended you set this to a number greater than the number
of Wi-Fi users.
of Wi-Fi users.
● DNS Mode — This specifies how the DNS servers (that the DHCP clients are to
communicate with) are obtained.
Auto — The DNS server specified by Sprint is used. DNS Relay is enabled by
default.