Xerox Phaser 8400 Betriebsanweisung

If you notice noises or odors that are not associated with your normal print operation:

Turn off the printer immediately

Disconnect the power cord from the electrical outlet 

Call an authorized service representative to correct the problem.

The power cord is attached to the printer as a plug-in device on the side of the printer. If it is 
necessary to disconnect all electrical power from the printer, disconnect the power cord from 
the electrical outlet.

Do not remove the covers or guards that are fastened with screws unless you are installing 
optional equipment and are specifically instructed to do so. Power should be OFF when 
performing these installations. Disconnect the power cord when removing covers and 
guards for installing optional equipment. Except for user-installable options, there are no 
parts that you can maintain or service behind these covers.

The following are hazards to your safety:

■

The power cord is damaged or frayed.

■

Liquid is spilled into the printer.

■

The printer is exposed to water.

If any of these conditions occur:

Turn off the printer immediately.

Disconnect the power cord from the electrical outlet.

Call an authorized service representative.

■

Do not attempt any maintenance procedure that is not specifically described in the 
documentation supplied with your printer.

■

Do not use aerosol cleaners. The use of supplies that are not approved may cause poor 
performance and could create a hazardous condition.

■

Do not burn any consumables or routine maintenance items. For information on Xerox 
supplies recycling programs, go to 

.

Your printer and supplies were designed and tested to meet strict safety requirements. These 
include safety agency examination, approval, and compliance with established environmental 
standards.

Your attention to the following safety guidelines helps to ensure the continued, safe operation 
of your printer.