Xerox DocuTech 6100 Production Publisher Betriebsanweisung

 
DT6180 HandyBook 

29  

 
NOTE: You should add Fuser Agent as soon as possible after the message is displayed. If Fuser 
Agent is not added the machine will stop running after approximately 5,000 prints and will not run 
until Fuser Agent is added.  
 
To add Fuser Agent:  

1.  Open the Processor Doors.  
2.  Place a drop cloth on the floor under the Fuser area to catch any Fuser Agent that may 

spill.  
 
WARNING: The Fuser area can reach temperatures of approximately 425 ° F / 218 ° 
C. Use extreme care to prevent burns when working in this area.  

3.  Grasp the green handle and lift up to open the Fuser Drawer. 

 

 

4.  Pull the Fuser Drawer all the way out of the machine until it stops.  

 
WARNING: Fuser Agent contains silicone which can cause irritation upon contact 
with the eye. Use latex gloves if you have them or make sure that you wash your 
hands with soap and water after you finish this procedure.  

5.  Pull the Fuser Agent reservoir out until it stops. 

 

 

6.  Remove the reservoir cap.