Xerox DocuTech 6100 Production Publisher Betriebsanweisung

 
DT6180 HandyBook                                                                                                                   73 

 

WARNING: Do not touch the heated areas of the Binder. The top of the Binder is 
approximately 425° F / 218° C. If the Binder has been in a 'Ready' condition, allow it 
to cool for at least one hour before continuing the procedure.  
 
To clean the Q1213 Sensor:  

1.  Fold a piece of A4 (210 mm x 297 mm / 8.3 x 11.7 inch) or 8.5 x 11 (216 mm x 

279 mm) inch paper in half.  

2.  Open the Finisher Doors. The handle to open the Finisher Doors is above and to 

the right of Paper Tray 3. 
 

 

 

 

3.  Pull the Binder drawer out of the machine until it stops.  

 

 

4.  Locate the Q1213 sensor on the top right side of the Binder on the Binder drawer 

rail.  
 
NOTE: The sensor has two parts, and they face each other; one is above the 
other. 

5.  Halfway back along the right, top edge of the Binder, you should see a metal 

bracket with small electronic components on it. The black plastic object with the 
orange and white wires is one part of the sensor, and the black cylindrical solid 
part about 51 mm (2 inches) below it, is the other part of the sensor.  

6.  Slip the folded sheet of paper under the sensor and brush it back and forth