Craftsman T825011L Benutzerhandbuch

Pump Plunger

• 

Block the vehicle's wheels for lifting stability.

• 

Refer to the vehicle manufacturer owner's 

manual to locate the approved vehicle lifting 

points.

• 

Position the jack so that the saddle will firmly 

contact the vehicle lifting point.

• 

Close the release valve by turning the handle 

clockwise until it stops.

• 

Pump jack handle until saddle nears contact 

with vehicle lifting point. Check to see that the 

saddle is centered and will contact lifting point 

firmly.

• 

Continue to pump jack handle to lift vehicle to 

desired height. 

• 

After lifting, support the load with appropriately 

rated vehicle support stands before working on 

vehicle. 

• 

Carefully open the release valve by slowly 

turning the handle counterclockwise.

• 

Refer to picture 1 when performing this step. 

Take off the screw located on handle piece 1. 

Attach handle piece 1 and 2 making sure to 

align the holes on both pieces. Reinsert the 

screw and tighten it.

• 

Lower the handle onto the bolt. Secure the handle 

in place by tightening the Handle Socket Screw.

Retaining Clip

•

Carefully remove the Retaining Clip (Picture 3)

from the handle socket. CAUTION: The socket 

will tend to spring upward when the clip is removed. 

To prevent possible injury, place one hand on 

top of socket to control its upward motion when 

removing clip with other hand.

•

 Sufficiently loosen the Handle Socket Screw to 

 insert the assembled handle (Picture 2).

 • Line up the square hole located at the bottom 

of the handle over the square bolt inside the 

Handle Socket.

Handle 

Socket Screw