Honeywell Honeywell Security | Protect What Matters Most Betriebsanweisung

Remote Phone Control Feature 

Enter

User Code (within eight seconds). Upon entering remote phone control mode the Lynx will 

announce 

“

System, enter code

”

. 

To remotely disarm system:........................................................... User Code + [1] 
To remotely arm in AWAY mode: .................................................. User Code + [2] 
To remotely arm in STAY mode: ................................................... User Code + [3] 
To remotely arm in AWAY or STAY mode with no delay:.............. User Code + [2] or [3] + [0] 
To remotely Bypass zones: ........................................................... User Code + [6] + zone no. 
To remotely activate Forced Bypass: ............................................ User Code + [6] + [#] 
To remotely check system status:.................................................. [

✻] 

To end remote phone session: Hang Up  or  ................................. User Code + [9]  

 

:  (1)  Check with your installer to see if the Forced Bypass mode has been enabled. 

 

(2)  When bypassing zones, make sure a confirmation beep sounds for each zone that has been 

bypassed.